Provide a detailed explanation of the soldering process used to install the ribs on a shotgun barrel

When we start talking about adding ribs to a shotgun barrel, it is important to note that there are a number of ways to go about attaching them to your firearm. Two of the most common include a less permanent epoxy method and what can be the tedious soldering method. To summarize the epoxy method, all you would need to do is rough up the spots the ribs touch the barrel, mix your epoxy and apply to the surfaces. Then just attach it to the barrel making sure it stays straight during the curing process and that an excess of glue does not squish out and harden. This can look bad and is hard to clean off sometimes.

Want to read more?

Subscribe to freestate-training-academy.com to keep reading this exclusive post.

Subscribe Now